| |
| |
Servo Press :- |
| |
| |
System Architecture :- |
 |
Target Force stop
|
|
Target distance stop |
|
Target force HOLDING & Time stop
|
|
Target distance HOLDING & time stop. |
|
Distance, Force, Time and FORCE RATE
monitoring.
|
|
Automatic Gain adjust by force feedback. |
|
All of the load detection, the distance detection and the servo driver are controlled by one controller equipped with RISC CPU. |
| |
The sampling speed achieves below 1msec.） |
|
Driving part uses the permanent magnet servo motor of the our company development. The drive circuit also digitalizes all.
|
|
Highly accurate press work is achieved by a variegated set parameter.
|
|
Even press-fitting the press and bonding can correspond to all the press work.
|
| |
|
| |
Improvement of production and quality: -
|
| |
There are a load, a distance, a rate and time in the judgment item and we will
promise highly accurate press work.
|
| |
Moreover, the parameter up to eight models is memorized and it contributes to the
generality of production |
| |
|
| |
Improvement of work area :-
|
| |
It is not and, therefore use with a clean room is also possible. The oil leakage and
oil mist need neither driving |
| |
oil nor driving air by driving part for the servo motor.
It will contribute to the miniaturization because (*S) |
| |
consolidated a control necessary for the press work in one controller |
| |
|
| |
Environmental improvement: -
|
| |
Because driving source is personally an electric power, electricity that the energy
|
| |
efficiency is good and useless is not consumed. Moreover, it is there are not
|
| |
wasted oil etc. generated by the oil pressure machine and nor either a gentle |
| |
press unit to the environment.
|
| |
|
| |
Internal Structure / Operation Principle
|
| |
 |
| |
|
|
The rotation of the servo motor is transmitted to the ball screw through the deceleration gear.
|
|
The rotation is converted into the direction of thrust with the ball screw nut.
|
|
The repulsion power from the axis point is converted into the load value in the loading cell.
|
|
The angle pulse of the resolver is converted into the distance value.
|
| |
|
| |
 |
| |
|
